Krontek KT160 Rev 4.10
3
SETTING THE CLOCK
1 Setting the time
If you are setting the time during Daylight Savings (DLS) do not add the extra hour i.e. if DLS time
is 8:30pm you must enter the time as 7:30pm (Standard Time). When you set the DLS period
(see 6 - Setting Daylight Savings) the clock will automatically adjust for DLS and add the extra
hour.
Press TIME, the clock will display the time that the key was pressed and the hours will flash. The
format is HHMMSS.
To change the hours use ADJ.
Press TIME again to advance to the minutes.
To change the minutes use ADJ.
Press TIME again to advance to the seconds.
Set the seconds about 10 seconds ahead of actual time then wait until actual time is the same
before pressing TIME to set the time.
Pressing SYS will exit time setting without saving any changes made.
2 Selecting 12/24 hour format
Press and hold SYS, the clock will display [12Hr] or [24Hr] depending on the setting.
Press ADJ to alternate between the two settings.
Use TIME to exit this mode.
3 Selecting Seconds or AM/PM
Press SYS twice (2) times, the clock will display [SEC on] or [SEC of] depending on the setting. If
seconds are turned off then the AM/PM indicator will be used.
Press ADJ to alternate between the two settings.
Use TIME to exit this mode.
Note: If AM/PM is selected the clock will default to the 12 hour format. This will not alter the 12/24
hour programmed setting.
