Kronos H-46 Series, Инструкция по эксплуатации, безопасности и запасным частям

Страница: 16 / 46

-A11-
5.7 Removing the Tool
Pull up the handle lever, pull the tool right / backwards
and off the strapping.
5.8 Seal - Control
A regular control of the seal is necessary. The seal can
be examined visually.
Make a seal, peel it apart and examine it as follows
：
Correct Seal
The seal must be completely welded over the whole
width of the strap on a length.
Minor quantities of fused plastic may overflow on sides.
Welding Time Too Short
The plastic strap is not welded over the whole width of
the strap.
The seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be
removed from the package!
Adjust the welding time. (see Page A9 5.3.3 Adjusting
the Sealing Time)
Welding Time Too Long
If the welding time is too long the straps are
overheated.
The fused plastic overflows on both sides of the straps.
The seal efficiency is affected.
Warning! Straps with insufficient seal strength must be
removed from the package!
Adjust the welding time.(see Page A9 5.3.3 Adjusting
the Sealing Time