kronings Robot Trolley 1500, Руководство пользователя

Страница: 15 / 34

Before Use: Preparing the Robot Trolley
Checking the status
1. Unpack the Robot Trolley and check that the Robot Trolley is clean and not broken
2. Make sure the Robot Trolley battery is charged according to instructions
Mounting the suspension fitting – standard bracket
REGIONAL VARIANTS
Some countries and makes of caravan may require a special bracket version. Please inquire with your dealer.
If there is a plastic cover over the side member system on the caravan, it can be helpful to remove it while mounting the
suspension fitting.
1. When mounting the suspension fitting from the Robot Trolley onto the caravan, start by gliding the two mounting
tubes, A1 and A2, together, and then placing them up inside the side members.
2. Next, loosely screw on the mounting bracket to the inner mounting tube, and screw the female piece to the
mounting bracket. If there are larger distances between side members, place the extension tube inside the inner
mounting tube.
The illustration below shows the assembled suspension fitting mounted on the side members 2 :
3. Slide the entire suspension fitting as far back on the side members as possible to put maximum weight on the
Robot Trolley. Do not push the suspension fitting so far back that mounting and removing the Robot Trolley
becomes difficult.
The following illustration shows the optimal placement of the suspension fitting on the caravan:
4. Push the Outer and Inner Mounting Tube as far from each other as possible, towards the sides of the side
members. Tighten the left and right brackets so that the bent undersides of these are positioned precisely against
the outer side of the side members. Make sure that the bolts are tightened to the maximum extent.
(If the caravan’s bearers are extremely narrow, and the mounting tubes cannot be pressed far enough together
upon mounting, you can use a hacksaw to shorten mounting tube A2. There must be minimum 10-15 cm inner
overlap of the Outer and Inner mounting tubes.)
2 Clamp and support plate for female mounting bracket only come with Model 2500.
A1: Outer mounting tube
Female for mounting bracket
Mounting bracket for inner
mounting tube
Inner extension tube
A2: Inner mounting tube