Krone Swadro 355, Руководство по эксплуатации, Страница: 14 / 26

14
The PTO shaft is taken apart for length adjustment.
Slide the corresponding PTO shaft halves into place on
the machinery and tractor.
The overload coupling
must be attached to the implement. Connect the
rotary swather to the rear hydraulics in the shortest
position for the PTO shaft. Hold both halves next to
each other and measure the correct length. Please refer
to the PTO shaft manufacturer's operating manual for
exact measuring and shortening procedures.
Risk of material damage: Do not raise the
implement before the length of the PTO
shaft has been adjusted.
• Always switch off the power take off before carrying out servicing, maintenance, repair or
assembly work on the rotary swather. Switch off the engine. Remove the ignition key.
Secure the tractor and rotary swather from rolling away.
• Nobody should be between the tractor and the rotary swather during raising or lowering
operations.
Lubricate PTO shafts with a multi-purpose grease at the
distances shown in the diagram. Observe the PTO shaft
manufacturer's operating instructions.
Use a vegetable based lubricant for this purpose.
Secure the protecting tubes (3) from rotating, with the
retaining chain (4).
Check the PTO shaft slewing range and free movement
space. Damage can be caused by the tractor or
implement coming into contact with the PTO shaft
(e. g. trailed appliance, three-point frame).
2.3.3 Installation and servicing of the PTO shaft.
2.3.2 Length adjustment of the PTO shaft
Gelenkwelle
8h
8h
8h
20h
40h
8h
40h
*
KS-317-0
1
2
4
4
3
3
KS-304-0