Krone EasyCut B 870 CV Collect, Оригинальная инструкция по эксплуатации

Страница: 55 / 122

Operation 8
Mowing 8.6
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en 55
ü
The support jacks are swivelled to the transport position and locked by means of the bolts.
„ Move the machine to the headland position, refer to page 53 .
„
Lower the cross conveyor belts, refer to page 54 .
„ Move the toggle switch (2) into the “ upper “ position and hold.
„
Actuate the double-action control unit (2+) until the mowers are raised from the headland
position to the transport position.
Note! To avoid damage to the machine caused by improper operation, switch off the operation
panel.
„
To switch off the operation panel, move the toggle switch (2) into the " middle " position.
8.6 Mowing
Preparing to mow
ü All points listed in the chapter "Start-up" have been fulfilled, refer to page 44 .
ü
The machine is in the working position, refer to page 53 .
ü
The machine is shut down and safeguarded, refer to page 24 .
ü The front guards are folded down, refer to page 50 .
ü The side guards are folded down, refer to page 51 .
ü
The rear linkage is blocked.
ü
The parking jacks are in the transport position, refer to page 52 .
Mowing
„
Adjust the lateral suspension arms, refer to page 61 .
„ Before driving into the crops, switch on the tractor PTO shaft at idle and slowly bring it up to
the rated speed of the machine.
„ Drive into the crops.
„
Check the ground pressure while mowing, refer to page 63 .
„
To ensure a clean cutting pattern, adjust the driving and cutting speeds to the prevailing
conditions (soil condition, state of the crop, height, density).
Driving into an obstacle
„ If the impact damage protection system triggers and the mower is swivelled backwards,
reverse the tractor until the impact damage protection system engages automatically.
Mowing small plots
The front mounted mower alone can be used to mow small plots of crops or narrow sections in
open fields. In doing so, the lateral mowers must be in the transport position.
INFORMATION
Leave the control units in the float position while mowing.