Krone EasyCut B 870 CR, Руководство по эксплуатации

Страница: 50 / 108

8 Operation
8.6 Mowing
50
EasyCut B 870 CR
Original Operating Instructions 150000706_01_en
Lifting both mowers simultaneously from working position to headland position
„ Move toggle switch (3) to “ centre ” position.
„
Actuate the control unit (2+) until both mowers are raised into headland position.
Moving right mower from headland position to working position
„ Move toggle switch (3) to “ left ” position.
„
Actuate control unit (2-) until the right mower is lowered into working position.
„ To mow, move control unit (2-) to float position.
Moving right mower from working position to headland position
„
Move toggle switch (3) to “ left ” position.
„ Actuate the control unit (2+) until the right mower is raised into headland position.
Moving left mower from headland position to working position
„
Move toggle switch (3) to “ left ” position.
„
Actuate the control unit (1-) until the left mower is lowered into working position.
„
To mow, move control unit (1-) to float position.
Moving left mower from working position to headland position
„
Move toggle switch (3) to “ left ” position.
„
Actuate the control unit (1+) until the left mower is lifted into headland position.
From headland position to transport position
ü
The PTO shaft drive is switched off.
ü
The support jacks are swivelled to the transport position and locked by means of the bolts.
„ Move the machine to the headland position, refer to page 49 .
„
Move the toggle switch (2) into the “ upper “ position and hold.
„ Actuate the double-action control unit (2+) until the mowers are raised from the headland
position to the transport position.
Note! To avoid damage to the machine caused by improper operation, switch off the operation
panel.
„ To switch off the operation panel, move the toggle switch (2) into the " middle " position.
8.6 Mowing
Preparing to mow
ü
All points listed in the chapter "Start-up" have been fulfilled, refer to page 41 .
ü
The machine is in the working position, refer to page 49 .
ü The machine is shut down and safeguarded, refer to page 24 .
ü
The front guards are folded down, refer to page 46 .
ü
The side guards are folded down, refer to page 47 .
ü The rear linkage is blocked.
ü
The parking jacks are in the transport position, refer to page 48 .