Krone Comprima V 180, Оригинальная инструкция по эксплуатации, Страница: 74 / 242

8 Operation
8.9 Fitting wheel chocks
74
Comprima V 180
Original Operating Instructions 150001053_00_en
The parking brake (2) is located on the front side of the machine on the drawbar. The parking
brake (2) is used to secure the machine from unintentionally rolling away, .
In order to prevent the machine from rolling away, also use the wheel chocks, refer to page 74 .
The figure shows the parking brake applied.
Applying the parking brake (2)
„
Push in the key (1) and apply the parking brake (2) until the resistance has increased
noticeably.
Releasing the parking brake (2)
„
Push in the key (1) and press parking brake (2) all the way down.
Attaching safety cable of the parking brake
2
3 1
RP000-399
The safety cable (1) applies the parking brake (3) if the machine breaks away from the tractor
while it is driving.
„
To attach the safety cable (1) to the machine, attach the safety cable (1) to the parking
brake (3). To do this, pull the safety cable (1) through the smaller loop of the safety cable (1)
and through the ring (2).
„
To attach the safety cable (1) to the tractor, attach the other end of the safety cable (1) to a
suitable point at the back of the tractor.
„
Ensure that the safety cable (1) cannot slip or become detached.
8.9 Fitting wheel chocks
1
2
RPG000-012
The wheel chocks (1) secure the machine against rolling away. 2 wheel chocks are affixed to
the machine.