Krone 870 HDP, Оригинальная инструкция по эксплуатации, Страница: 485 / 568

Terminal – menus [Medium Plus/Comfort Plus Electronics] 8
Alarm messages 8.16
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
79
8.16 Alarm messages
WARNING
Personal injuries and/or machine damage caused by non-observance of alarm
messages
When alarm messages are ignored and the malfunction is not remedied, personal injuries
and/or serious damage to the machine could result.
„
When alarm message is displayed, remedy the malfunction, refer to page 79 .
„ If the malfunction cannot be remedied, contact KRONE customer service.
KMC - 522064- 7
EQG000-034
The display shows an alarm message if a malfunction occurs on the machine. At the same time
an audio signal will be heard (continuous horn sound). Description, possible cause and remedy,
refer to page 79 .
Acknowledging the alarm
„
Press .
Æ The acoustic signal stops.
If the malfunction occurs again, the alarm message will also appear again.
8.16.1 Error Messages
Components may be repaired or replaced by a qualified service centre only. Contact your
dealer.
Before you contact your dealer, collect information about the error by
• noting down the error number.
• Visually check the sensor/actuator, refer to page 79
• If an actuator is defective, run an actuator test to identify the status of the actuator, refer to
page 76 .
• If a sensor is defective, run a sensor test to identify the status of the sensor, refer to
page 69 .
The more information you give your dealer, the easier it is to eliminate the cause of the error.
Performing visual inspection
ü The machine is shut down and safeguarded, refer to page 21 .
„
Check sensor/actuator externally for damage.
„
Check connector cable and plug connection for damage and tight fit.