13
User – Set parameters
User – Set parameters
You can change further parameters to adapt the heating system to
your requirements.
1
Turn selector switch to (parameter setting).
▷
The display shows .
2
Turn the rotary knob clockwise until the parameter you want to
change appears in the left-hand side of the display:
01
to
04
(heat
slope to hot water, based on program).
Press the OK button.
▷
Display flashes.
4
Use the rotary knob to set the desired value.
5
Press the OK button to confirm.
6
After you have made the setting, continue with step 2 if you want
to change further parameters, or turn the selector switch back
to
.
▷
The table - List of parameters P01 to P04 - shows the possible
settings.
▷
Your remote control will only display those parameters for which
there are sensors connected.
List of parameters P01 to P04
P. no. Parameter
Setting range
Factory setting
Own values
01
Heat slope
0.20–3.00
1.20
02
Room sensor influence
OFF, 0–20
10
03
Room sensor correction
-5 to +5 °K
0
04
Hot water according to program
0 = Off
1 = "Heating program 1“
2 = "Heating program 2“
3 = 1 hour before heating
4 = 24 hours hot water
4
