Elster GmbH
Postfach 28 09, D-49018 Osnabrück
Strotheweg 1, D-49504 Lotte (Büren)
T +49 541 1214-0
F +49 541 1214-370
GB-8
D
GB
F
NL
I
E
Contact
If you have any technical questions, please contact
your local branch office/agent. The addresses are
available on the Internet or from Elster GmbH.
We reserve the right to make technical modifications
in the interests of progress.
[email protected], www.kromschroeder.com
Designed lifetime
The Pressure Equipment Directive (PED) and the
Energy Performance of Buildings Directive (EPBD)
demand regular checks on and maintenance of
heating systems in order to ensure a high level of
use in the long term, a clean method of operation
and safe function.
The service life on which the construction is based,
hereinafter referred to simply as the “designed
lifetime”, is compiled from the relevant standards.
You can find further explanations in the applicable
rules and regulations and on the afecor website
(www.afecor.org).
This information on the designed lifetime is based on
using the product in accordance with these operat-
ing instructions.
The product must be serviced at regular intervals.
Once the specified designed lifetime has been
reached, the safety-related functions must be
checked in accordance with the section entitled
“Maintenance”.
If the product passes the aforementioned function
tests, you can continue to use it until the next sched-
uled maintenance operation. At this point, these tests
must be repeated.
If the product fails one of the aforementioned tests,
it must be replaced immediately.
This procedure applies to heating systems. For
thermoprocessing equipment, observe national
regulations.
Designed lifetime (based on date of manufacture) in
accordance with DIN EN 14382 Safety devices for
gas pressure regulating stations and installations:
Designed lifetime
Switching cycles
Time [years]
JSAV
–
15
Long-term use in the upper ambient temperature
range accelerates the ageing of the elastomer ma-
terials and reduces the service life (please contact
manufacturer).
Declaration of conformity
We, the manufacturer, hereby declare that the prod-
ucts JSAV 25 – 40, marked with product ID No. CE-
0085AS0202, comply with the requirements of the
listed Directives and Standards.
Directives:
– 2009/142/EC
– 79/23/EC
Standards:
– DIN EN 14382 (07/09)
The relevant product corresponds to the type tested
by the notified body 0085.
The production is subject to the surveillance proce-
dure according to annex II, paragraph 3 of Directive
2009/142/EC and annex II, module D of Directive
97/23/EC.
Elster GmbH
Scan of the Declaration of conformity (D, GB), see
www.docuthek.com.
Contact
