Open the INTspector App and select the
USB Gateway
button and wait for the connection to be
established as shown by the next screen in step 3. (this may take approx. 20 seconds)
Once the connection to the
INT 69 i 2 Diagnose
is established, the following screen appears
automatically. It may take a few additional seconds for the
Change Parameters
button to
automatically appear.
#1
#2
#3
#4
set amps from
table
Leave blank
Inspector settings for
PTC
overloads
150%
#5
#6
#7
** Note: If you tap the buttons to the left & button turns
green
, this locks out compressor if safety trips
•
Disabled
(NO dRdt / Locked rotor recognition)
•
Level 1 active
(dRdt / Locked rotor detection
Is
active)
•
Level 1 and 2
(dRdt Is active as an error and a warning)
•
Level 1 and 2
only warning
(dRdt as a warning only)
Change to Active
