background image

Tel:

 +44 (0)1274 657 088   

Fax:

 +44 (0)1274 657 087   

Web:

 www.cromptonlamps.com

Images are for information only. Phoebe LED shall not be held liable for improper operation of the luminaire 

in circumstances where procedures and specifications have not been followed correctly. Crompton Lamps Limited 2020

300mm

294mm

82mm

Environmental Protection

Waste electrical products should not be 

disposed of with household waste. Please 

recycle where facilities exist. 

Check with your Local Authority or retailer for 

recycling advice.

THANK YOU for buying this PHOEBE LED product. 

To help ensure this luminaire gives complete satisfaction please only use it according to the 

following instructions, and then pass the instructions to the appropriate person for retention and future reference.

This instruction sheet is relevant to Phoebe LED KRIOS Emergency Twin Spot 

product code: 13995

Warning

1.  Installation only to be carried out by a qualified electrician

2. Please ensure mounting surface is suitable
3.  Do not operate if product is damaged
4.  IP65 suitable for wet weather outdoor use

Product 

code

Description

Power 

(W)

Colour

13995

Krios Twin Spot

2.3

6000K Daylight

 a. 

Switch off power at circuit.

 

b.  

Remove the front panel from 

the body by removing the four 

corner fixing screws.

 

c.  

Take out the fixings bag from 

the inside of the unit.

BEFORE YOU START

PLEASE READ ALL THE 

INSTRUCTIONS CAREFULLY

ONLY ONCE INSTALLATION 

IS COMPLETE

Turn power 

back on at 

the mains

CIRCUIT TESTING

For high voltage circuit insulation 

testing disconnect mains input 

supply first

 

(Do not circuit test using a Megger)

Turn power 

off at the 

mains

PRIOR TO INSTALLATION

  a.   

Drill out the intended cable 

Ø20mm entry hole suitable for 

your installation.

 

b.

  Secure the luminaire to the 

mounting surface at the Ø4mm 

screw points indicated using the 

supplied self tapping screws.

to 

mains 

240V

4

 

a.

   Connect to mains power in accordance 

with current wiring regulations, the mains 

connector is located on the lower right of 

the circuitboard (see wiring diagram).

 

 b.   

Mark installation date on battery and 

connect battery cable.

Wiring Diagram

5

 a.

  Refit the front panel to the body with the 

screws from part 1b.

 

b.

 Switch on the power at circuit.

 a.   

Fit the waterproof connector to 

the entry point and pass the mains 

supply into the luminaire.

  

b.

  Pass the mains cable through the 

cable retention bracket and tighten.

 

c.

  Wire the luminaire to mains in 

accordance with current wiring 

regulations, the mains connector 

is located on the lower right of the 

circuitboard.

Viewing 

Distance

(b)

(a)

(a)

(b)

(b)

(b)

(b)

(a)

(b)

To 240V Mains

(a)

AC INPUT

(b)

(b)

Отзывы: