KRHÜNER 36291, Инструкция по эксплуатации

Страница: 8 / 15

The blade track is set at the optimum setting ex-factory. However, the blade track can change as a result of
voltage fluctuations, In the event of under voltage, the blade track can shorten and, in the event of
overvoltage, it can lengthen. If necessary, by changing the setting of the adjusting screw, you can set this
blade track yourself. To do so, use a screwdriver or a thin coin.
•
Using the on/off switch, switch the equipment on (Fig. 1a).
•
Turn the adjusting screw clockwise until you hear a loud noise (Fig.2b).
•
Then turn the adjusting screw anti-clockwise unti the loud noise stops (Fig.2a).
Cutting-Iength adjustment
With the adjustment lever al the side, the cutting length can be adjusted. Even during operation.
•
Lift the adjustment lever upwards-minimum cutting length (Fig .3a).
•
Lower the adjustment lever-maximum cutting length (Fig.3b).
Cutting with attachment combs (depending on model)
Depending on the desired haircut, the equipment can be operated with or without attachment combo. To
this end, the cutting-Iength adjustment lever has to be raised (Fig.3a). Depending on the model,
attachment combs (1.5mm /6mm/ 10mm/ 16mm) are included in the scope of supply.
Attaching/removing the attachment comb
•
Place the attachment comb onto the cutting edge of the cutting set and press it down onto the
cutting set in the direction of the housing until it clicks into position (Fig.4a).
•
The attachment comb can be easily removed by lifting the hook in the direction of the arrow
(Fig.4b).