KRESS KUS20P, Инструкция по безопасности и эксплуатации

Страница: 10 / 12

10
Angle grinder
KUS20P
COMPONENT LIST
1. ON / OFF SWITCH
2. HAND GRIP AREA
3. AUXILIARY HANDLE
4. SPINDLE LOCK BUTTON
5. WHEEL GUARD FOR GRINDING
6. OUTER FLANGE
7. INNER FLANGE
8. SPINDLE
9. SPANNER
Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Type KUS20P (S20P- designation of machinery,
representative of Angle Grinder)
KUS20P
Voltage
230-240~50/60Hz
Power input
1400W
Rated speed
9500/min
Protection class
/II
Spindle thread
M14
Disc size 125 mm
Disc bore
22.2mm
Machine weight
2.0 kg
ACCESSORIES
KUS20P
Spanner
1
Auxiliary handle
1
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose the
type according to the work you intend to undertake.
Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
ASSEMBLY AND OPERATION
ACTION FIGURE
ASSEMBLY
Assembling Auxiliary Handle See Fig. A
Assembling Grinding See Fig. B
Adjusting Outer Flange Clamping See Fig. C1 C2
OPERATION
Using On/Off Switch See Fig. D
Hand Grip Areas See Fig. E
Rough Grinding
Warning! Never use a
cutting disc for roughing.
Replacing the Carbon Brush See Fig. F
WORKING HINTS FOR
YOUR ANGLE GRINDER
1. Always start at no load to achieve maximum speed
then start working.
2. Do not force the disc to work faster, reducing the
Disc’s moving speed means longer working time.
3. Always work with a 15-30 angle between disc
and workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only cut
in the opposite direction to the disc rotation. If you cut
in the same direction as the disc rotation the disc may
push itself out of the cut slot.
5. When cutting very hard material best results can be
achieved with a diamond disc.
6. When using a diamond disc it will become very hot.
If this happens you will see a full ring of sparks around
the rotating disc. Stop cutting and allow to cool at no
load speed for 2-3 minutes.
7. Always ensure the workpiece is firmly held or
clamped to prevent movement.