KRESS KU420, Инструкция по безопасности и эксплуатации

Страница: 11 / 12

11
Circular Saw KU420
WORKING HINTS FOR
YOUR CIRCULAR SAW
If the machine is severely hot, please let your
machine run for 2~3 minutes without any load for
cooling. Try to avoid continuous use at a low speed.
If your power tool becomes overheated,
Always cut with a blade with proper materials and
thickness. The more teeth of the saw, the better
quality. Always ensure that the workpiece is fixed or
clamped to prevent movement. Keep close to the
cutting line when supporting the large panel. Any
movement of the workpiece may affect the cutting
quality. Since the cuts of the upwards saw blade
may cause torn burr on the top surface/edge, so
make the side used for appearance downwards
when cutting. Cutting too fast may significantly
reduce the performance of the tool and the life of
the saw blade. Always keep the better surface of
the workpiece downwards to ensure the opening as
small as possible. Only sharp blades of the correct
size will be used.
Rip saws (for softer materials only) can only
be operated by people who are skilled and
experienced.
WARNING: During this operation, the saw
tooth are exposed, so please pay special
attention to safety.
Clearly mark the area to be cut on the workpiece,
set the cutting depth on the machine, and place the
front edge of the base plate used for the machine
against the surface of the workpiece (Fig. J1, J2);
the cutting guide indication coincides with the
surface marking line of the workpiece. Ensure
that the saw blade is close to the surface of the
workpiece without contact, and turn the guard lever
to open the movable shield. For turning on, take
the front edge of the base plate as a pivot point
and slowly cut the saw blade into the workpiece.
Wait until the saw blade is completely cut into the
workpiece, and then the movable guard can be
released for normal operation.
MAINTENANCE
Your power tool requires no additional lubrication
or maintenance. There is no parts requiring special
maintenance Only simple maintenance on the
machine is needed according to the following
requirements.
1. Wipe clean with a dry cloth. Never use water or
chemical cleaners to clean your power tool to avoid
compromise on the performance of the machine
shell or causing accidents such as electric leakage.
2. Always keep the air inlet clean and unobstructed,
and prevent debris from being accumulated at the
air inlet, which may affect the cooling of motor.
In addition, try not to use it in dusty environment.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted
for environmentally friendly recycling.
The plastic components are labeled for categorized
recycling.