KRESS KU076, Инструкция по безопасности и эксплуатации, Страница: 9 / 12

9
Portable tile cutter KU076
the desired measure.
Raise
for smaller cutting depths
Lower
for greater cutting depths
Use a ruler, scale or something similar to adjust
the required depth.
Retighten the depth guide lock wing nut.
Maintain a uniform feeding speed during the
entire cutting procedure. If a perfect cut is
desired, the diamond cutting disc must protrude
2 mm out of the material.
3. ADJUSTING BEVEL CUT (SEE FIG. C)
Loosen the bevel-angle preselection wing bolt
(10) for cutting angle setting.
Pivot the machine sideways until the desired
cutting angle is set on cutting angle scale (11).
Re-tighten the bevel-angle preselection wing
bolt.
4. OPERATION
— Clamp down the workpiece if it does not
stay in place owing to its own weight.
— Do not load the machine so heavily that it
comes to a standstill.
— Caution! Diamond cutting discs become
very hot during operation; do not touch them
until they have cooled down.
When cutting, do not press, tilt or oscillate.
Gently slide it forward with a speed adapted to
the material being worked on.
Do not brake cutting discs that are slowing down
to a stop by using side pressure.
1) SWITCHING ON AND OFF (SEE FIG. D)
Depress on/off switch then lock-on button,
release on/off switch first then lock-on button.
Your switch is now locked on for continuous use.
To switch off your tool, just depress and release
on/off switch.
2) CUTTING DIRECTION (SEE FIG. E)
The cutting direction is very important.
The machine must always run counter rotation,
so push the machine forwards! Otherwise, the
machine may be pressed out of the cut in an
uncontrolled fashion.
5. CARBON BRUSH REPLACEMENT (SEE FIG. F)
There are two motor brushes which can be
easily accessed on the front and back of the
motor housing.
Unscrew the carbon brush cap, and remove
the carbon brush. If the carbon has worn down
to 6mm, it should be replaced. Always replace
both brushes at the same time. Insert the new
brush and replace the brush cap. Check that the
tool is working. Before use, allow it run for a few
minutes to enable the brushes to settle.
It’s advisable to re-lubricate the transmission
system every second time you replace your
carbon brushes, because grease loses its
lubrication properties.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance. There are no user serviceable
parts in your power tool. Never use water or
chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted for
environmentally friendly recycling.
The plastic components are labeled for
categorized recycling.