KREMLIN
Page 5
Manual : 573.001.212
5. START
UP
Captions :
A
B
C
D
E
F
G
H
Pump (B + C)
Air motor
Fluid section
Air regulator "MOTOR AIR"
Gauge
Air regulator "GUN AIR"
Gauge
Air inlet valve
I
J
K
L
M
N
O
P
Ground
Relief-valve (depending on version)
Protection spring
Suction rod
Air hose (static conductor)
HP fluid hose
Airmix ® gun or airspray gun
"T" lubricant ( 1/4 l / 0.07 US gal)
(For specific installation, please contact your KREMLIN REXSON representative).
Start up procedure :
1 - Ground the pump.
2 - Fill up the pump fluid outlet flange with KREMLIN "T" lubricant or with an appropriate cleaning
solvent.
3 - Unscrew the air regulators (D and F).
4 - Interconnect the equipment with the air pressure network (clean air - P < 6 bar / 87 psi). Install a
water drop, model 3/8 if it is necessary.
5 - Connect all the hoses (air hose and fluid hose) as well as the gun (O).
6 - Remove gun air cap by unscrewing the cap ring.
FLUSHING WITH SOLVENT
7 - Immerse suction rod (L) into material container.
8 - Open pump air pressure valve (H).
9 - Point the spray gun, not supplied with air, towards the material container and press the trigger.
10 - Increase the air regulator (D) so that the pump runs slowly (Pressure between 0,5 and 1 bar /
7.25 to 14.503 psi). When material flows out regularly, release the trigger.