Note
You can set up your KPS 28c to play a musi-
cal selection in three different areas. Connect
the CAST output to a CAST-enabled system
in one listening area, the balanced output to
a system in a second listening area, and the
single-ended output to a system in a third lis-
tening area. The musical selection will play
simultaneously in all three areas.
4. Connect the cables from your digital audio
or video source to the optics output (16) or
coaxial (17) digital output on the KPS 28c
back panel.
IMPORTANT
When switching between active sources, always
lower the volume to off or mute the output. This
ensures that the next source played does not
damage your system with a high output transient.
POWER ON
1. Connect the AC power cord to the IEC
power connector (20), then connect the AC
power cord to the wall socket. The KPS 28c
is in the stand-by mode. The red stand-by
LED (3) illuminates.
2. Press the power button (4) or pwr key (22)
to switch the KPS 28c from the stand-by to
the operational mode. The blue power LED
(5) illuminates and you hear a click. The
KPS 28c is ready to play music.
This section provides more information about
operating the KPS 28c.
TO PLAY A COMPACT DISC
1. Use the open/close button (2) or open key
(23) to open the compact disc transport (1).
2. Place a compact disc on the transport.
3. Use the open/close button (2) or open key
(23) to close the compact disc transport (1).
Playback automatically begins from the first
track. Adjust system volume through your
preamplifier or amplifier.
4. Press the stop button (11) or key (28) to end
compact disc playback.
Note
You can also begin track playback by pressing
the play button (12) or key (29), or select a track
using the direct track access keypad (26), the
track forward and back buttons (8, 9) or keys
(30) or the search forward and back keys (31).
HOW TO WRITE A PROGRAM
This short-term programming lets you store a
maximum of 20 tracks in a program sequence.
Note
Track forward, track back, repeat, and pause func-
tion normally within a programmed sequence. For
a description of these remote control keys, see
Remote Control Description, pages 11-12.
1. Press the prog (program) key (34) on the
remote control.
PROGRAM
appears in the
compact disc display (7).
14
Krell KPS 28c
Operating The KPS 28c
Connecting Your KPS 28c,
continued
See Figure 2 on page 8
