Operating the Standard KPE,
continued
Krell KPE
11
6. To alter loading from the 100 Ohm factory setting, set one loading
switch from each loading switch bank to the CLOSED (on) posi-
tion to obtain the desired setting. The loading switch banks are
situated on the left and right of the circuit board.
7. The loading switches are labeled as follows:
1
10
Ohms
2
25
Ohms
3
47
Ohms
4
100
Ohms
5
249
Ohms
6
475
Ohms
7
825
Ohms
8
1000
Ohms (1 K)
All open 47000
Ohms (47 K)
Each switch bank is labeled OPEN on one side. When a rocker switch on
the switch bank is depressed toward the side labeled OPEN, the switch is
OPEN, or off. When a rocker switch is depressed away from the side
labeled OPEN, the switch is CLOSED, or on.
If the manufacturer does not supply a loading value, use 100 Ohms
(switch 4) on both channels.
Experiment with different types of loading until you find the one that sounds
best. Always have one switch CLOSED (on) for both channels.
8. Place the topcover back on the Standard KPE and replace the
topcover screws.
LOAD SETTINGS
Notes
