Setup
1 Remove the Drill Guide Block from the drill-guide socket of your
Kreg
®
K3, K4, or K5 pocket-hole jig.
2 Slide the Plug Cutter guide block into the drill-guide socket, seating
it all the way at the bottom. Secure the guide with the locking pin.
3 Slide the stop collar onto the Plug Cutting Bit until it rests on the
bit shoulder. Tighten the stop-collar set screw with the hex wrench.
Chuck the bit into your electric drill.
ATTENTION
Electric drills commonly run at speeds from
1300 rpm to 2500 rpm. To obtain good quality plugs from a
lower rpm drill, slow the feed rate. Higher rpm drills produce
good quality plugs at a faster feed rate, but produce more heat.
When using a high rpm drill, pace your production rate to allow
time for the bit to cool.
!
Shoulder
Stop Collar
