General Safety Guidelines
!
WARNING
When using electric tools, always follow the safety precautions
below
to reduce the risk of fire, electric shock,
and personal injury. Read all these instructions before attempting to operate this product.
SAVE THESE INSTRUCTIONS
.
• Before using the Accu-Cut™, read, understand, and follow the safety
warnings and operation instructions included with this product and provided
by your saw manufacturer. Keep all guards and safety devices in place.
• Wear proper eye, ear, and respiratory protection when operating your saw.
• Use a sharp blade designed for the type of material you are cutting.
• Always disconnect your saw from power before making adjustments
to the saw or Accu-Cut™.
• Wipe the guide strips with a damp cloth and remove dust and debris
from the workpiece before positioning the track on the workpiece.
• The Accu-Cut™ is designed for use with both tracks joined together.
Do not attempt a cut using only one track section without first clamping
the track section to the work piece.
• Ensure that the saw blade will not contact the aluminum track during the cut.
• Do not attempt a cut when any part of the Accu-Cut™ interferes with
the operation of the saw blade guard.
• Fully support both the workpiece and the cutoff piece to prevent
binding and kickback.
• Adjust the depth of cut so the saw blade protrudes ⅛″ [3mm] through
the workpiece during the cut.
• Keep your hands away from the saw blade during operation.
• Secure your workpiece to ensure it doesn’t move during the cut.
• Do not use excessive force when cutting. Maintain a steady
and controlled pace.
• Allow the saw blade to come to a complete stop before removing the
saw/sled assembly from the track.
• Do not leave unattended saw resting on the track or starting block.
• Maintain your tools and accessories. Check for misalignment or binding of
moving parts, loose fasteners, broken parts, and any other condition that may
affect safe operation. If an unsafe condition is discovered, correct it before use.
Parts
A
2 Tracks
I
2 Base-plate Clamps
B
4 Guide Strips
(Pre-Installed)
J
1 Indexing Stop
C
2 Connector Bars
K
3 Machine Screws
D
8 Set Screws
L
3 Hex Nuts
E
1 Starting Block
M
1 Indicator Clip
F
1 Filler Strip
N*
1 Cursor
G
1 Sled
O*
1 Wedge
H
2 Set Screws
P*
1 Handle
*Part functional only on Kreg Rip-Cut™.
Upper blade guard
Before You Begin
Welcome to the Kreg Accu-Cut
TM
!
With your new Accu-Cut
TM
, you are sure to have a
lifetime of quality cutting experience. The Accu-Cut is
designed to work best with circular saws that have
a metallic upper blade guard. Saws with a plastic
upper blade guard may allow excessive deflection
between the blade and the base plate causing
undesirable results when paired with the Accu-Cut
TM
.
Please check the upper blade guard on your circular
saw. If your upper blade guard is plastic, Kreg
recommends not using this circular saw with the
Accu-Cut
TM
.
!
ATTENTION
