12/24V Power Starter PBS 124010
WARNING!
Read entire manual carefully before operating the product!
To ensure the product a longer life and more efficient, please note:
•
Before first use, put the switch to
“OFF”
position and charge the battery
fully.
•
Fully charge the battery after each use.
Operational Instructions
1. Jump Starting
1.1 Turn ignition off before making cable connections.
1.2 Make sure the power switch is on the Off position until clamps are connected
to the vehicle battery.
1.3 Connect positive (red) clamp to positive (POS, P, +) ungrounded post of
battery.
1.4 Connect negative (black) clamp to negative (POS, P, -) of battery.
1.5 Turn the power switch to the 12V or 24V position according to your car or
truck.
Attention:
When switch is on 12V-position never connect on 24V!
1.6 Crank the engine for 3-5 seconds. If the engine does not start within 10
seconds, stop cranking and wait at least 4 minutes before attempting to start the
vehicle again. (This permits the battery to cool down.)
1.7 After the engine starts, turn the power switch to the Off position. Then
disconnect the negative (black) clamp and then the positive (red) clamp in that
order.
1.8 Always return the cables to their stored position.
1.9 Recharge the jump starter as soon as possible after use.
2. Charging
Turn the power switch to
OFF
position!
Plug the charger jack into the socket and the charger adapter into mains supply.
Check the charging status by pressing the TEST button.
3. Check internal battey status
Press on the TEST button; check the voltage of battery from the voltmeter. If the
needle is in the:
•
Green area, the jump starter is charged and ready to be used.
•
Yellow area, the jump starter needs to be charged as soon as possible.
•
Red area, the jump starter cannot be used and needs to be charged
immediately.
4. 12V output socket
If the jump starter is overloaded by output current (15A max), the circuit will be cut
off automatically. Reduce output power of electrical equipments and the circuit will
be restored automatically in a few minutes.
Recharge the jump starter as soon as possible after using the output socket.
CAUTION:
1. Do not use the battery if the cable or plug is damaged. To avoid damage of
cable and plug, never pull the calbe to disconnect the charger.
2. Repairs should be carried out by experts only. Otherwise it may cause
considerable danger for user.
3. Avoid short circuit of the product :
Don’t touch the poles by any conductive material.
Don’t store the battery in a box in which the poles might touch other objects.
4. Don’t store Jumpstart in places in which the temperature could exceed 50°C.
