KRAUSMANN U73012-00, Руководство по эксплуатации

Страница: 16 / 20

16
U73012-00 KRAUSMANN POWER TOOLS
1
2
English | EN
4. Functional description
and specifications
Intended use
The device is designed for screwing or unscrewing
as well as for drilling in wood, metal, ceramic and
plastic. Following these instructions will ensure
safe installation and operation of the device.
Insert the plug on the charging unit into
a power socket and turn the power on if
required.
Insert the battery with the charging output
interface to the charging port. The charging
time depends on the capacity of the battery
and the type of the charger.
Place the battery pack and charger on a flat
non-flammable surface and away from flammable
material when re-charging the battery pack.
Charging the battery
Always switch off the tool before insertion or
removal of the battery pack. To remove the battery
pack, withdraw it from the tool while pressing the
release button. To insert the battery pack, slide the
pack into the body of the tool. Always insert it all
the way until it locks in place with a little click. If not,
it may accidentally fall off the tool, causing injury
to you or someone around you. Do not use force
when inserting the battery pack. If the pack does
not slide easily, it is not being inserted correctly.
Removing or inserting the battery
pack
WARNING:
When battery charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the tool
to cool down before re-charging to achieve the full charge.
The three lights
5
on the side of the tool body (red,
orange, green) indicate the battery capacity status.
Battery capacity indicator
Red: 0% - 20%
O range: 20% - 60%
G reen: 60% - 100%.
Power supply
No load speed
Max. Torque
Impact rate
Socket holder
Tool weight 12 V
0-2400 rpm
100 Νm
0-3000 ipm
1/4” hexagon
770 gr
Tool U73012-00
Using the tool
Switching ON and OFF
To switch the tool on, press and hold the ON /
OFF switch 1 . To turn the tool off, release the ON /
OFF switch 1 (fig 1). The ON / OFF switch controls
the variable speed, depending on the amount of
pressure you apply to the ON / OFF switch. Light
pressure on the trigger results in a low rotational
speed. Further pressure on the switch results in an
increase in speed.
fig 1
Working LED light
The working LED light 6 can be used in poor
lighting conditions to illuminate the work area. The
working LED light will light up as soon as you press
the ON / OFF switch 1 .
Changing the bit
WARNING:
Always turn the tool off and remove the battery from
machine before doing any work on the machine.