KRAUSE 949752, Инструкция по сборке и руководство пользователя

Страница: 13 / 136

13
ProTec ® XS 1000
– The tower must not be moved at a pace faster than normal walking speed.
– The tower must only be moved longitudinally or diagonally.
– The surface on which the mobile scaffold tower is being moved has to be capable of bearing the tower’s weight.
– It is prohibited to raise or attach the mobile scaffold tower to another object or device.
– The mobile scaffold tower must only be moved up to wind force 6 (~ 45 km/h) wind speeds.
– The castors must always be arrested before ascending the tower.
3.4 Checking the site of use before assembly, after moving or changing the mobile
scaffold tower‘s configuration
The following points must always be checked before every use of the mobile scaffold tower:
– The mobile scaffold tower always has to be vertical relative to the ground. Where necessary, it may have to be
realigned to ensure the same.
– All of the tower’s component must be fitted as set out in the Assembly Instructions and User Manual.
– The ballast weights and outriggers must be fitted as specified in these Assembly Instructions and User Manual.
– The brakes on the castors have to be locked every time the tower has been moved.
– Make sure there are no electrical hazards.
– Make sure there are no changes in the environment that could pose a hazard to tower’s safe use.
3.5 Required tools
– Spirit level
4. Assembly
101
4.1 General
The mobile scaffold tower must only be assembled once the personnel involved have read the product information
(section 2) and safety instructions (section 3) in full. Assembling and disassembling the tower requires at least 2 persons.
Mobile scaffold towers with a height in excess of 6 metres require 3 persons to assemble. Only use original parts in compli-
ance with the manufacturer‘s instructions.
Pages 112 and 113 contain a table with the individual steps for assembling the scaffold. Please note that
certain steps may have to be repeated multiple times. For this reason, please make sure to perform all of the
individual steps shown for your scaffold, which will depend on your scaffold’s height. A detailed explanation of
the individual steps can be found from section 12 onwards.
*If you are planning to build low even working-height platforms (e.g. 6.70 m) with the packages for odd working-
height platforms (e.g. 7.70 m), you will need 1 additional diagonal braces Art. no. 912879
INFORMATION ON USING THE ASSEMBLY INSTRUCTIONS
The Assembly Instructions describe how to assemble the ProTec ® XS 1000 mobile scaffold tower in a number of different
configurations. Please read the entire assembly instructions before assembly and take note of the differences between the
different assembly options. Depending on the height of the topmost working platform, the mobile scaffold tower will either
have to be fitted with ballast weights (page 124). Please read the corresponding information in this manual.
4.2 Fitting the set of stabilisers
If using the mobile scaffold tower on a wall, it can be prevented from tipping over by fitting it with a set of stabilisers. The
use of stabilisers does in no way remove the need for the required ballast weights and outriggers. When using stabilisers,
always fit at least two stabilisers directly below the topmost working platform (see drawing page 129). Always use ring
bolts to fasten the device to the wall.