KRATKL LEO SERIES, Инструкция по установке и эксплуатации, Страница: 56 / 124

56
firing process in the fireplace indicate the need to replace the batteries in the receiver. used batteries
located in the receiver can overheat, spill or even explode. Do not use batteries that have been
exposed to the sun, moisture, heat or vibration. Install only batteries of the same type and the same
manufacturer. Do not install new batteries with worn ones. The kit can optionally include the G60-
ZB90 power module. This module is powered by four 1.5V AA batteries and should be connected
directly to the receiver in the place of the Ac adapter connection. The additional power supply modu-
le eliminates the need for batteries in the receiver. Optionally, customers can buy a cable connecting
the interrupter block and the receiver for the gas control system, equipped with a switch. The switch
also protects the system against uncontrolled flow of gas through the controller.
Construction of the device trim
Before performing the trim, protect the gas control system components from dirt. fireplace trim sho-
uld be made of non-combustible materials (including its floor and ceiling) according to the current
construction regulations. If the fireplace is powered by natural gas (NG), the exhaust grille should be
placed under the ceiling. Supplying liquid propane - butane (LpG) requires from the fitter execution
of enclosures equipped with the exhaust grille above ground level.
Removing the glass
ATTENTION !!!
Removing the glass should only take place off cooled fireplace with gas supply off and discon-
nected power supply.
The device is equipped with a heat-resistant glass that withstands temperatures up to 800°c. To
exchange it, in the first place, remove t he side grilles. The grills are fitted with special splines. The
side glass clamping strips should be unscrewed with an Allen screwdriver. In the next step, remove
the lower grille and unscrew the remaining glass clamping strip. After the above steps, you can now
easily remove the glass. Depending on the model of series 100 LEO, disassembly of the glass may be
slightly different from the one shown.