Kramer Yarden VT-1, Руководство пользователя

Страница: 6 / 11

Kramer Electronics Ltd.
Yarden VT-1 / Yarden VT-2 - Connecting the Vibrating Transducer Speaker 4
Connecting the Vibrating
Transducer Speaker
Always switch off the power to each device before connecting it to your
Yarden VT-1 / Yarden VT-2 .
To connect the Yarden VT-1/Yarden VT-2 as illustrated in the example in Figure 3 :
1. Carefully remove the speaker grille.
The grille is magnetically attached to the speaker.
2. Prepare the wires:

Measure the length from the speaker to the receiver and cut the wires accordingly (to
similar lengths).

Strip the ends of the wires to expose a length of approximately 1/4 inch.
3. For Yarden VT-2 only:

Adjust the tap setting according to the power requirements of the amplifier.
4. Connect the wires:

Connect the positive terminal on the receiver to the positive (red) connector.

Connect the negative terminal on the receiver to the negative (black) connector.
5. Break the knock off hole on the grille and pass the wires through the hole.
6. Peel the blank side of the double-sided adhesive sticker (included) and carefully attach it
to the rear side of the speaker.
7. Peel the printed side of the sticker and attach the speaker to a surface at the desired
location.
8. Screw the four mounting screws in place until the speaker is firmly attached.
9. Reattach the grille.