Using the WP-230
7
5.1 Installing the WP-230
To install your
WP-230
:
1. Connect the 5 RGBHV BNC output connectors
1
to the pre-installed
wiring in the wall box opening that connects to the XGA acceptor (for
example, a projector), as Figure 5 defines.
Figure 5: WP-230 RGBHV Outputs
2. Connect the LINE AUDIO OUT and / or the PC AUDIO OUT terminal
blocks, as one of the following:
Figure 6: Connecting the LINE AUDIO OUT / PC AUDIO OUT
3. Connect the wires of the coax cable to the CV OUT pins
2
, taking care that
polarity is correct
.
4. Connect the wires of the coax cable to the Y/C OUT pins
3
, taking care
that
polarity is correct
.
5. Connect your 12V DC power supply to the
POWER
pins
4
, taking care that
polarity is correct
.
6. Insert the
WP-230
directly into the wall box opening, and then mount the
front panel securely using the screws.
1 The WP-230 could be used for component HDTV by connecting YPbPr in place of GBR, and not connecting H and V
2 Connect the composite video wire to the CV OUT pin and the Ground wire to the GND pin (see Figure 8)
3 Connect the luminance signal “Y” wire to the Y pin and the Ground wire to its corresponding GND pin, and connect the
chrominance signal “C” wire to the C pin and the Ground wire to its corresponding GND pin (see Figure 8)
4 Connect the wire labeled “+” to the +12V pin, and the wire labeled “–” to the GND pin
