Kramer VW-4, Руководство пользователя

Страница: 12 / 40

Kramer Electronics Ltd.
VW-4
– Configuring VW-4
10
Configuring VW-4
We recommend that you configure the video-wall after connecting the video-wall. You can
configure the video-wall by:
•
Configuring SETUP DIP-Switches on page 10 .
•
Using the VW-4 App on page 11 .
•
Configuring the video-wall via protocol commands (see Protocol 3000 on page 30 ).
Once the video-wall settings are defined, adjust the image on the video-wall (see Adjusting
the Video-Wall Image on page 24 ).
Configuring SETUP DIP-Switches
Use the SETUP DIP-switch settings to configure a basic video-wall (without defining bezel
correction) of up to 4x4, consisting of 1 to 4 VW-4 devices. This can be very useful for quickly
testing video-wall functionality when setting up the system.
When the video-wall size is configured using the DIP-switches, you cannot set it via the
configuration app. To use the app, make sure that all DIP-switches are OFF.
DIP 1 DIP 2 DIP 3 DIP 4 Columns x Rows Layout Notes
OFF OFF OFF OFF Basic setup is not used (default) The setup is configured via the
APP, not via the DIP-switches.
OFF OFF OFF ON
Full size picture (“1x1” wall)
Image appears on all displays.
(Each display shows the full
image).
OFF OFF ON OFF N/A
OFF OFF ON ON N/A
One VW-4 Device
OFF ON OFF OFF 2x2 wall (0)
OFF ON OFF ON 4x1 wall (0)
OFF ON ON OFF 1x4 wall (0)
OFF ON ON ON N/A
Three VW-4 Devices
ON OFF OFF OFF 3x3 wall, first unit (0)
ON OFF OFF ON 3x3 wall, second unit (1)
ON OFF ON OFF 3x3 wall, third unit (2)
ON OFF ON ON N/A
8