VS-84HN - Operating the VS-84HN 8x4 HDMI Matrix Switcher
15
6.5
Switching Between Protocol 2000 and Protocol 3000
To switch from Protocol 2000 to Protocol 3000 and vice-versa using the front
panel buttons
:
1. Press Output buttons 1 and 3 at the same time.
Protocol 3000 is active.
2. Press Output buttons 1 and 2 at the same time.
Protocol 2000 is active.
Note that when sending consecutive protocol commands make sure to
maintain at least a 200ms delay between commands.
After performing EDID get/store commands, a 1 sec delay is required
before sending another protocol command.
6.6
Connecting via RS-232
You can connect to the
VS-84HN
via an RS-232 connection using, for example, a
PC. Note that a null-modem adapter/connection is not required.
To connect to the product via RS-232:
Connect the RS-232 9-pin D-sub on the rear panel of the
VS-84HN
via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need to
be connected) to the RS-232 9-pin D-sub port on your PC
6.7
Connecting via Ethernet
You can connect the
VS-84HN
via the Ethernet, using a crossover cable (see
Section
) for direct connection to the PC or a straight through cable (see
Section
) for connection via a network hub or network router.
After connecting the Ethernet port, you have to install and configure your Ethernet Port. For
detailed instructions, see the “Ethernet Configuration (FC-11) guide.pdf” file in the technical
support section at
http://www.kramerelectronics.com
6.7.1
Connecting the Ethernet Port directly to a PC
You can connect the Ethernet port of the
VS-84HN
to the Ethernet port on your PC
via a crossover cable with RJ-45 connectors.
i
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
