Kramer Electronics Ltd.
VS-62H
– Configuring and Maintaining the VS-62H
18
Configuring and Maintaining the
VS-62H
This section describes the configuration and maintenance of the
VS-62H
and consists of:
•
).
•
Resetting the device to factory default settings (see
Resetting the VS-62H to Factory
).
•
).
Setting the DIP-switches
The DIP-switches dictate the behavior of the
VS-62H
.
All DIP-switches are off by default.
#
Feature
Description
1
HDCP support on inputs
On
—Disable HDCP support on all inputs
Off
—Enable HDCP support which is defined
by P3000 commands
2
Video mode switching Output 1
On
—Auto
Off
—Manual
3
Last connected/Priority mode Output 1
When DIP-switch 2 is set to Auto (ON):
On
—Enable Last Connected mode
Off
—Enable Priority mode where the priority
of each input is defined by the input
number, (1 is the highest priority)
4
Video mode switching Output 2
On
—Auto
Off
—Manual
5
Last connected/Priority mode Output 2
When DIP-switch 4 is set to Auto (ON):
On
—Enable Last connected mode
Off
—Enable Priority mode where the priority
of each input is defined by the input
number, (1 is the highest priority)
Resetting the VS-62H to Factory Default Settings
To reset the device to factory default settings
:
1. Power off the device.
2. Press and hold down the Reset button on the rear panel.
3. While holding down the Reset button, power on the device.
4. Wait a few seconds and release the button.
The device is reset to its factory settings.
