KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-21HDMI 2x1 HDMI Switcher
6
6 Operating the VS-21HDMI 2x1 HDMI Switcher
This section describes how to operate the
VS-21HDMI
, using the SELECT
button. The
VS-21HDMI
functions in two modes: the PC mode
1
(see section
6.1) and the DVD mode (see section 6.2).
6.1 Working in the PC Mode
This section describes how to acquire / change the EDID (see section 6.1.1) and
how to reset the default EDID (see section 6.1.2) when working in the PC mode.
6.1.1
Acquiring / Changing the EDID
You can work with the default EDID or acquire / change the EDID.
To acquire or change the EDID:
1. Connect the new output display device.
If no output display device is connected to the output, the default EDID
will be stored in the non-volatile memory.
2. Connect the power while keeping the SELECT button pressed until the
LEDs start to blink.
3. To change the EDID and store it in the non-volatile memory of:
INPUT 1, release the SELECT button while the IN 1 LED blinks
INPUT 2, release the SELECT button while the IN 2 LED blinks
Both INPUT 1 and 2, release the SELECT button while both the IN 1 and
the IN 2 LEDs light
4. When a certain input—INPUT 1 or INPUT 2—is selected the EDID
information comes directly from the display. When the input is not
selected, the
VS-21HDMI
uses the virtual EDID stored in the
non-volatile memory.
6.1.2
Resetting the Default EDID
To reset the default EDID, do the following:
1. Disconnect the power.
2. Disconnect the output cable.
3. Connect the power while keeping the SELECT button pressed until the
desired INPUT LED blinks.
1 The default
