Rear Panel
#
Feature
Function
17
AUDIO IN
Unbalanced
Connectors
HDMI 3.5mm Mini
Jack
Connect to an unbalanced audio source for audio takeover of the HDMI 1 and HDMI 2
embedded audio.
18
PC 3.5mm Mini
Jack
Connect to the unbalanced audio of the computer graphics source (from 1 to 2).
19
DP 3.5mm Mini
Jack
Connect to the unbalanced audio source for analog audio takeover of the DisplayPort
embedded audio.
20
CV (L, R) RCA
Connect to the unbalanced stereo audio of the composite video source (from 1 to 2)
21
S/PDIF IN RCA
Connect to the digital audio source of the component video (Y, Pb, Pr)
22
MIC IN 3.5mm
Mini Jack
Connect to a microphone
23
COND/DYN MIC DIP-switch
Select between a condenser and a dynamic type microphone
24
S/PDIF OUT RCA Connector
Connect to a digital audio acceptor
25
LINE OUT (L, R) Terminal Block
Connector
Connect to the L and R unbalanced stereo audio acceptor
26
REMOTE IR 3.5mm Mini Jack
(opening)
Covered by a cap. The 3.5mm
connector at the end of the
internal IR connection cable fits
through this opening
Connects to an external IR receiver unit for controlling the machine via an IR remote
controller (instead of using the front panel IR receiver)
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely
control the machine (only if the internal IR connection cable has been installed)
27
ETHERNET RESET Button
Press while turning power off and then on, to reset the Ethernet settings to their factory
default state
28
SPKR Terminal Block Connector
Connect to a balanced stereo audio acceptor (speakers)
29
VIDEO
INPUT
Connectors
HDMI
Connect to the HDMI source (from 1 to 2)
30
PC 15-pin HD
Connect to the computer graphics source (from 1 to 2)
31
Y RCA
Connect all three connectors to the component video source
32
PB RCA
33
PR RCA
34
CV RCA
Connect to the composite video source (from 1 to 2)
35
DISPLAYPORT
Connect to the DisplayPort source
36
VIDEO
OUTPUT
Connectors
PC 15-pin HD
Connect to a computer graphics acceptor
37
HDMI
Connect to an HDMI acceptor
38
DGKAT RJ-45
Connect to a DGKat receiver (for example, Kramer
PT-572+
)
39
RS-232
9-pin D-sub Port
Connect to the PC or other serial controller
40
ETHERNET
Connector
Connects to the PC or other Controller through computer networking
41
REMOTE
Terminal Block
Connectors
For remotely switching the inputs and PIP input via contact closure switches
42
Power Connector with Fuse
AC connector, enabling power supply to the unit
43
POWER
Switch
Switch for turning the unit ON or OFF
Step 3: Mount VP-770
To rack mount the machine, attach both rack ears
(by removing the screws from each side of the
machine and replacing those screws through the
rack ears) or place the machine on a table.
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.