Connecting the VP-31KSi 3x1 UXGA/Audio STEP-IN Switcher
9
To connect
1
Figure 3
the VP-31KSi, as illustrated in the example in
:
1. Connect up to three
2
Remote Step-in Panels
(for example, the
SI-1VGA
or
SI-VGAT
) to the
VP-31KSi
15-pin HD VIDEO INPUT connectors
3
2. Connect up to three UXGA computer graphics sources to the
SI-1VGA
15-pin HD video connectors.
and to
the 3.5mm mini jacks (from 1 to 3).
3. Connect up to three unbalanced audio sources to the 3.5mm mini jack audio
connectors on the
SI-1VGA
panels.
4. Connect the 15-pin HD VIDEO OUTPUT connector to a UXGA acceptor (for
example, a projector).
5. Connect the RJ-45 CAT 5 OUT connector to a compatible TP receiver (for
example, the Kramer
TP-120
).
6. Connect either, but not both:
the unbalanced audio 3.5mm AUDIO OUTPUT jack to an unbalanced
audio acceptor (for example, power amplifier)
—OR—
the balanced audio 5-pin terminal block (see
Section 5.1
) to an audio
acceptor (not shown in
Figure 3
)
7. Connect up to three remote, contact closure input selection switches to the
REMOTE terminal block (see
Section 5.2
).
8. Connect a PC over a LAN to the Ethernet for remote operation.
9. Set the DIP-switches (see
Section 5.6.1
) for remote operation. You can
connect a PC and/or controller to the:
RS-232 port (see
Section 5.3
)
RS-485 port (see
Section 5.6.1
)
10. Connect the power adapter to the device and to the mains electricity.
5.1 Connecting the Balanced/Unbalanced Stereo Audio Output
This section illustrates how to wire the devices to the balanced audio output:
•
A balanced stereo output connection, see
Figure 4
•
An unbalanced stereo output connection, see
Figure 5
1 Be sure that the power is switched off on each device before connecting it to your VP-31KSi. After connecting all the devices to your
VP-31KSi, switch on the power of the VP-31KSi, and then switch on the power of each device
2 You do not have to connect all the inputs
3 The cable used must connect all 15 pins
