VP-2L - Connecting the VP-2L
5
4
Connecting the VP-2L
Always switch off the power to each device before connecting it to your
VP-2L
. After connecting your
VP-2L
, connect its power and then
switch on the power to each device.
To connect your
VP-2L
UXGA Line Amplifier
, as the example in
Figure 2
illustrates,
do the following:
1. Connect a computer graphics source to the INPUT 15-pin HD connector.
2. Connect the OUTPUT 15-pin HD connector to an acceptor (for example, a
display).
3. Connect the 5V DC power adapter to the 5V DC socket and connect the
transformer to the mains electricity or use the included USB cable to power
the unit as described below.
4. If required, adjust the video output signal level and/or cable compensation
equalization level.
Use a screwdriver to rotate the trimmers to adjust the appropriate level.
The
VP-2L
is supplied with the
USB cable that:
•
Has a USB-A connector at one end and a 5V DC jack at the other
•
Connects to any USB port to power the unit
The internal Kramer P/N for this USB cable is 2518-0214003 C-UAM/DC35(THREAD)-3
To connect the
VP-2L
UXGA Line Amplifier
using this cable:
1. Connect the 5V DC jack of the cable to the 5V DC socket of the
VP-2L
(instead of using the 5V DC power adapter) and connect the USB-A
connector of the cable to the USB port of the display or computer.
The
VP-2L
receives power from the display or computer without needing a
power supply.
i
