Kramer VM-4HDT, Руководство пользователя

Страница: 11 / 29

Kramer Electronics Ltd.
VM
‑
4HDT , VM
‑
3HDT , VM
‑
2HDT
– Operating the VM
‑
4HDT, VM
‑
3HDT and VM
‑
2HDT 9
Operating the VM
‑
4HDT,
VM
‑
3HDT and VM
‑
2HDT
This section describes the following functions
•
IR and RS-232 Signal Routing on page 9 .
•
Acquiring an EDID on page 12 .
IR and RS-232 Signal Routing
The VM
‑
4HDT can send or receive IR and RS-232 commands via the four HDBT output
ports.
Each signal can pass commands from the VM
‑
4HDT to a single output, several outputs or all
of the outputs or the other way around, from the output/s to the VM
‑
4HDT .
The IR/RS-232 signal routing is enabled via the SETUP DIP-switches (see Setting the
DIP-Switches on page 9 ).
Setting the DIP-Switches
This section defines the SETUP DIP-Switches:
Figure 7: VM
‑
4HDT DIP-Switches
Output #
IR Routing is
enabled when: RS-232 Routing is
enabled when:
OUT 1 DIP 1
– OFF
DIP 5
– OFF
OUT 2 DIP 2
– OFF
DIP 6
– OFF
OUT 3 DIP 3
– OFF
DIP 7
– OFF
OUT 4 DIP 4
– OFF
DIP 8
– OFF