VM-400HDCPxl
Quick Start
P/N: 2 9 0 0 - 3 0 1 0 8 4 QS
Rev: 4
Scan for full manual
VM-400HDCPxl Quick Start Guide
This guide helps you install and use your
VM-400HDCPxl
for the first time.
www.kramerav.com/downloads/VM-400HDCPxl
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
VM-400HDCPxl
1:4 DVI Distributor
1 bracket set
1 Quick start guide
1 Power adapter and cord
4 Rubber feet
Step 2: Get to know your VM-400HDCPxl
#
Feature
Function
1
OUT DVI-I Connectors
Connect to DVI acceptors OUT 4 is located on the front panel OUT 1 to OUT 3 on
the rear panel.
2
INPUT DVI-I Connector
Connect to an DVI/HDMI (over DVI-D connector) source.
3
PROG Mini USB Connector
Use to send RS-232 Commands.
Connect to a PC to perform firmware upgrades (via K-Upload) and work with the
EDID Designer.
K-Upload and EDID Designer can be downloaded from our Web site at:
www.kramerav.com/manual/VM-400HDCPxl
To use the mini USB port, you need to download and the Kramer USB driver from
our Web site at:
www.kramerav.com/support/product_downloads.asp
and install it.
4
EDID SETUP Button
Press to capture the input EDID or select the default EDID.
5
IN LED
Lights when an active input signal is detected.
6
OUT LEDs
Light when an active output acceptor is detected (from 1 to 4).
In the EDID mode indicate the EDID type acquired.
Flashes when a non-HDCP acceptor is connected to the output and the input is
HDCP-encrypted (the content is displayed for only a few seconds).
7
ON LED
Lights when the unit receives power.
8
5V DC Connector
Connects to the 5V DC power supply.
Step 3: Install the VM-400HDCPxl
Install
VM-400HDCPxl
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/VM-400HDCPxl
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/VM-400HDCPxl
