Step 3: Install the VM-3DT
Install
VM-3DT
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/VM-3DT
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/VM-3DT
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VM-3DT
. For best results, we recommend
that you always use Kramer high-performance cables to connect AV equipment to the
VM-3DT
.
HDBT RJ-45 Pinout:
Use a straight pin-to-pin cable with
RJ-45 connectors.
We recommend that for HDBT cables, the
ground shielding be connected/soldered to
the connector shield.
DIP-Switch Setup:
To enable/disable IR and RS-232 routing, set the DIP-switches as follows:
Note
: DIP-switches 4 and
8 are reserved for future
use. By default, all DIP-
switches are set to OFF
(up).
PIN EIA /TIA 568B
PIN
Wire Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
Out #
IR Routing is enabled when:
RS-232 Routing is enabled when:
6
Green
OUT 1
DIP 1
– OFF (up)
DIP 5
– OFF (up)
7
Brown / White
OUT 2
DIP 2
– OFF (up)
DIP 6
– OFF (up)
OUT 3
DIP 3
– OFF (up)
DIP 7
– OFF (up)
For optimum range and performance use the
recommended Kramer cables available at
www.kramerav.com/product/VM-3DT
Step 5: Connect the power
Connect the power adapter to the
VM-3DT
and plug the adapter into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power supply that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
for updated safety information.
