Kramer VM-1411, Руководство пользователя

Страница: 16 / 25

Connecting the Distribution Amplifiers
14
6 Connecting the Distribution Amplifiers
This section describes how to connect the:

VM-5ARII
Video Audio Distribution Amplifier , see section  6.1

VM-20ARII
1:20 Programmable Video Audio Distributor , see
section

6.2

VM-1411 1:10 Video/Audio Distributor , see section

6.3
6.1 Connecting the VM-5ARII Video Audio Distribution Amplifier
To connect the
VM-5ARII
, as shown in the example in Figure 5 , do the
following
1
:
1. Connect the input video source (for example, a composite video player) to
the VIDEO INPUT BNC connector.
2. Connect the input audio source (for example, the audio from a composite
video player) to the AUDIO IN RCA connectors noting the right and left
channels.
3. Connect the VIDEO OUT 1 to 5 BNC connectors to up to 5 acceptors
2
(for
example, composite video recorders).
4. Connect the AUDIO OUT 1 to 5 RCA connectors to up to 5 acceptors
2
(for
example, the audio input on the composite video recorders).
5. If needed, connect the VIDEO LOOP BNC connector to an acceptor (for
example, a composite video display or another VM-5ARII ) and set the
termination pushbutton to 75

.
6. Connect the power cord
3
to the unit (not shown in the illustration) and then
to the mains electricity. Switch on the power.
7. If needed, adjust the VIDEO GAIN or EQ controls or the AUDIO GAIN on
the front panel.
1 Switch OFF the power on each device before connecting it to your VM-5ARII. After connecting, switch on the VM-5ARII
power and then switch on the power on each device
2 You are not required to connect two acceptors
3 Use the power cord supplied with the unit