VM-114H2C
Quick Start
P/N:
2900- 301224QS
Rev:
2
Scan for full manual
VM-114H2C Quick Start Guide
This guide helps you install and use your
VM-114H2C
for the first time.
Go to
www.kramerav.com/downloads/VM-114H2C
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-114H2C
2 Input 1:4 HDMI DA/2x CAT5 Outputs
1 Set of rack ears
4 Rubber feet
IR remote control transmitter with batteries
1 Power supply (12V DC)
1 Quick start guide
IMPORTANT NOTICE!
We highly recommend using only Kramer UNIKAT cables with these products. If using 3
rd
party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your VM-114H2C
#
Feature
Function
1
IR Remote Control Sensor
Sensor for the remote-control IR transmitter
2
IR LED
Lights yellow when receiving signals from the IR remote control transmitter
3
REMOTE IR 3.5mm Mini Jack
Connect to a remote IR sensor
4
EDID READ Button
Press (when one of the output LEDs is flashing to indicate a selected output) to read the
selected EDID
5
EDID SELECT Button
Press repeatedly to cycle through the outputs to select from which one to read the EDID.
The relevant LED flashes
6
OUTPUT 1~4 LEDS
The relevant LED lights green when an acceptor is connected to the output
Also lights or flashes during EDID setup (see Section 5.2)
7
POWER LED
Lights green when the unit receives power
8
INPUT SELECTOR Button
Press to select an input. The relevant IN 1 HDMI/IN 2 CAT5 LED lights
9
IN1 HDMI LED
Lights green when HDMI input 1 is selected
10
IN2 CAT5 LED
Lights green when the TP CAT 5 input 2 is selected
11
RS-232 9-pin D-sub (F) Connector
Connect to a PC or remote controller
12
12V DC Power Connector
Connect to the +12V DC power adapter, center pin positive
13
IN1 (HDMI) Input HDMI Connector
Connect to an HDMI source
14
IN2 (CAT5) Input RJ-45 Connector
Connect to a TP source
15
OUT 1, OUT 2 HDMI Connector
Connect to the HDMI acceptors
16
OUT 3, OUT 4 TP RJ-45 Connector
Connect to the TP acceptors
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
