TP-583R
#
Feature
Function
1
IN LED
Lights green when an active, far-end source device input signal is
detected via the HDBT link.
2
OUT LED
Lights green when an active sink (acceptor) connection is detected.
3
LINK LED
Lights green when an HDBT link is established with the HDBaseT
transmitter.
4
ON LED
Lights green when the device receives power.
5
LINE RJ-45 Connector
Connect to the RJ-45 HDBT LINE connector on a transmitter (for
example,
TP-583T
,
TP-780T
and so on).
6
HDMI® OUT Connector
Connect to an HDMI acceptor.
7
SETUP DIP-switches
Set the operation DIP-switches.
8
RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector
Connect to a laptop to control the receiver or perform firmware
upgrade.
Connect to a serially controlled device (for example, the HDMI OUT
acceptor) to enable its control by a remote controller device (for
example,
SL-240C
) that is connected to
TP-583T
.
9
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
10 12V DC Power Connector
12V DC connector for powering the unit.
Step 3: Install TP-583T/TP-583R
Install
TP-583T
/
TP-583R
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/TP-583T, TP-583R
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/TP-583T, TP-583R
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
TP-583T
/
TP-583R
. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to
TP-583T
/
TP-583R
.
