Connecting the TP-145 and the TP-146
9
9
An RS-232 cable with a 3 pin terminal block connector at one end to the
TP-146
RS-232 port
1
3. Using STP cabling
, and a 9-pin D-SUB connector at the other end to
the RS-232 port on the AV display system
2
4. Connect the power adapter to the power socket on the
TP-145
and/or
TP-146
(if needed), and connect the adapter(s) to the mains electricity.
, connect the LINE OUT RJ-45 connector on the
TP-145
to the LINE IN RJ-45 connector on the
TP-146
.
5. On the
TP-146
:
If necessary, adjust the video output signal level and/or cable
compensation equalization level with a flat screwdriver
If necessary, set the horizontal sync switches, vertical sync switches, and
the sync mode jumpers (see
Section 4.2.1
)
5.1
Transmitting via RS-232
It is possible to transmit data (for example, using a PC) between the
TP-145
and
TP-146
via the RS-232 terminal block.
Prepare an RS-232 cable with a 9-pin D-sub connector at one end, and a 3 pin
terminal block at the other end as defined in
Table 4
and
Figure 5
.
Table 4: RS-232 Pinout Connection
Terminal
Block
9-pin D-sub
Connector
TxD
Pin 2
RxD
Pin 3
GND
Pin 5
Figure 5: RS-232 Pinout Connection
5.2
Wiring the Twisted Pair RJ-45 Connectors
When using STP cable, connect/solder the cable shield to the RJ-45 connector shield.
Table 5
and
Figure 6
define the TP pinout using a straight pin-to-pin
cable with
RJ-45 connectors.
1 As defined in
Figure 5
and
Table 4
2 For details of how to wire a TP RJ-45 connector, see
Section 5.2