Step 3: Install the TBUS-204
A
: Cut an opening in the table using the metal cut-out template. Before cutting check the latest cut-out dimensions
from the Kramer website at
www.kramerav.com/downloads/TBUS-204
•
Place the cut-out template on the surface of the table exactly where you want to install the
TBUS-204
.
•
Attach the cut-out template to the table with the included screws.
•
Following the
inside
edge of the template, cut a hole in the table surface with a sabre or keyhole saw according to the
dimensions.
•
Unscrew and remove the template from the surface of the table and clean the table surface.
Take care not to damage the table. If needed, you can download a full-scale template from the Kramer website at
www.kramerav.com/downloads/TBUS-204
Take care not to damage the table. Kramer Electronics is not responsible for any damage caused to the table.
B: Insert
TBUS-204
into the cut-out opening:
Carefully insert the unit into the prepared opening.
Under the table, insert the mounting clamps into the
mounting clamp slits at the desired height (on both the front
and rear sides of the unit).
Make sure that the upper outer rim is situated parallel to the
edge of the table.
Insert the mounting screws through the holes in the
mounting clamps. Tighten the mounting butterfly nuts to
secure the unit to the table surface and then lock with the
mounting butterfly screws.
C: Connect the power cable from underneath the
TBUS-204
and then power or charge devices as required.