SPK-W511T - Installing the SPK-W511T
7
3. Pass the speaker wires through the round hole in the mounting bracket (see
Section 4.3
4. Adjust each speaker to the appropriate tap setting (see
).
Figure 2
).
Set the tap according to the power requirements of the speaker based on its location in the
room (for example, a speaker located in a remote corner may require additional power)
Figure 2: Adjust Tap Selector
5. Connect one of the + and – terminal block pairs on the rear panel (see
Figure 1
) by connecting the wire from the:
Negative terminal on the receiver into the negative terminal block of the
speaker
Positive terminal on the receiver into the positive terminal block of the
speaker
6. Repeat step 5 for the other speaker (see
Figure 7
).
7. If required, connect the + and - terminal blocks to the + and - terminal blocks
of an adjacent speaker (as illustrated in the example in
Figure 6
).
4.3
Installing the Mounting Bracket
To install the mounting brackets, do the following:
1. Mark the location of the mounting holes on the wall.
2. Screw the mounting screws onto the wall at the location that you want to
mount the speakers.
If the location is backed by wall studs, you can use the wood screws
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
