Installing the Speakers
3
5 Installing the Speakers
This section explains how to:
Choose the best location for your speakers (see section 5.1)
Install the speaker wires (see section 5.2)
Install the mounting brackets (see section 5.3)
5.1 Choosing the Best Location
Before installing the speakers:
Experiment by placing the speakers in different locations before finally
deciding on the most suitable location
Be sure that the wall type is appropriate for the mounting brackets, that is,
either solid wood, bricks, concrete, hollow building blocks, or wood studs.
You cannot mount the brackets on gypsum walls
Check that the mounting location is free of obstructions, such as electrical
piping, AC ducts or water lines, and so on
5.2 Installing the Speaker Wires
To install the speakers, do the following:
1. Prepare the wires for the speakers:
Use two stranded 16-gauge speaker wires
1
of similar length
2
Measure the length to reach from each speaker to the receiver, adding
some access wire length to let you easily remove the speakers from
the bracket without having to disconnect the input wires
2. Strip the ends of the wires approximately 3/8 inch.
3. Pass the speaker wires through the round hole in the mounting bracket.
4. Unscrew the negative (black) screw-type connector, insert the wire from
the negative terminal on the receiver, and retighten.
5. Unscrew the positive (red) screw-type connector, insert the wire from the
positive terminal on the receiver, and retighten.
6. Insert the brackets (see section 5.3)
1 It is recommended to use the Kramer BC-2S cables
2 For achieving high quality sound
