Kramer SP-14, Руководство по эксплуатации

Страница: 21 / 33

21
TC Output Format
Output options are embedded LTC, embedded VITC, embedded LTC+VITC, and none (no time code
put on the data stream).
Status Display Mode
Changes the information being displayed on the LCD from general information on the video modes to
time code information.
4.7. Input Select
The list of available inputs can be scrolled through using the Up and Down arrows. The new input is not
selected until the Select/Enter key is pressed again. The list of inputs are:
DVI, HDMI, Analogue, 3G-SDI 1, 3G-SDI 2, S-Video, Component, CVBS 1, CVBS 2 and Test Pattern.
Test patterns can be generated by SP-14 without needing an input connected. When Test Pattern is
selected as the input, the required test pattern can be chosen from the Input Channel Config section of
the Miscellaneous menu or with the menu off by toggling through the test patterns with the up and down
keys.
NB: Some complex test patterns can take many seconds to draw, during which time the screen will be
blank and the LCD will indicate “Busy”. This is not a fault.
4.8. Input Adjust
This menu contains adjustments associated with setting up inputs to the unit. Use the Up and Down
arrows to scroll to the required sub-menu and press the Select/Enter key to enter the sub-menu. The
following sections list the sub-menus.
4.8.1.
Input Levels
This menu contains parameters related to the level and colour of the input signal.
Luma Gain
Control of luma gain
R-Y Gain
Control of colour gain
B-Y Gain
Control of colour gain
Luma Cutoff
Control of luma offset
R-Y Cutoff
Control of colour offset
B-Y Cutoff
Control of colour offset
Saturation and Hue
Control of video saturation and hue
Black Level IRE
Used to select 7.5 IRE black level set-up adjustment
Input Gamma
Set the Gamma to match the input source