SL-12 - Overview
5
3.1
Defining the SL-12 Master Room Controller
This section defines the
SL-12
.
Figure 1: SL-12 Master Room Controller
#
Feature
Function
1
ETHERNET
RJ-45
Connector
Connects to the PC or other serial controller through
computer networking LAN to control several AV products
over Ethernet
2
DEFAULT
Recessed
Pushbutton
Press to reset to factory default definitions:
IP number
192.168.1.39, Mask
– 255.255.0.0,
Gateway
– 0.0.0.0
First disconnect the power supply and then connect it again
while pressing the DEFAULT button. The unit powers up and
loads its memory with the factory default definitions and
erases all stored presets
3
IR
Output
Terminal Blocks
Connect to IR emitter cables (from 1 to 4)
4
GPI/O
Terminal Blocks
Connect to various analog and digital sensors (from 1 to 4)
5
RELAYS
Terminal Blocks
Connect to low-voltage relay-driven devices (from 1 to 8)
6
RS-232
Terminal Blocks
Connect to the RS-232 devices (from 1 to 4)
7
RS-485
Terminal Block
Pins B (-) and A (+) are for RS-485; Pin G may be
connected to the shield (if required)