21
KRAMER ELECTRONICS LTD.
9
TAKING CARE OF YOUR MACHINE
Do not locate your machine in an environment where it is susceptible to dust or moisture. Both of these may
damage the electronics, and cause erratic operation or failure. Do not locate your machine where temperature
and humidity may be excessive. Doing so may also damage the electronics, and cause erratic operation or
failure of your machine. Do not clean your machine with abrasives or strong cleaners. Doing so may remove or
damage the finish, or may allow moisture to build up. Take care not to allow dust or particles to build up inside
unused or open connectors.
10
TROUBLESHOOTING
NOTES
1. Please note that if the output signal is disturbed or interrupted
by very strong external electromagnetic interference, it should
return and stabilize when such interference ends. If not,
disconnect power from the machine and reconnect again to
reset the machine.
2. If the recommended actions still do not result in satisfactory
operation, please consult your KRAMER Dealer.
10.1
Power and Indicators
Problem Remedy
No Power
1.
Confirm that the rocker switch is in the “ON” position, and that the switch is
illuminated.
2.
Confirm that power connections are secured at the machine and at the
receptacle. Make sure the mains receptacle is active. If still there is no power,
remove power cord from AC outlet and then, using a flat head screwdriver,
remove the fuse holder located directly below the power connector on your
machine.
3.
Confirm that the fuse is good by looking for the wire connected between the
ends of the fuse. If the wire is broken, replace the fuse with another, with the
same rating.
10.2
Video Signal
Problem Remedy
No video at the output
device, regardless of
input selected.
1. Confirm that your source and output devices are powered on and connected
properly. The input of your machine should be of an identical signal format or
standard at the output of your source. Signals at the output of your machine
should be of an identical signal format or standard as at the input of your display
or acceptor.
2. Confirm that any other device in the signal path have the proper input and/or
output selected.
3. Confirm that the maximum cable length was not exceeded. Disappearance of the
SDI signal may be a result of the “cliff effect”.
