Step 3: Install the RTBUS-24
To mount the unit, follow these steps:
A
: Using any standard cup bit drill with a diameter
ranging from 111mm to 114mm
(4.37” to 4.49”), drill
a hole in the table in the desired location.
.
B
: Insert the
RTBUS-24
into the hole cut into the table making sure the
outer rim is firm against the surface of the table.
C
: From underneath the table, slide the
mounting brackets into the appropriate slots.
D
: Tighten the butterfly mounting screws securely upward against the
table.
E
: Lock the mounting screws into position with the locking butterfly
screws.
F:
Connect the cables:
Connect devices to the surface.
Connect the HDMI connector on the underside to an
HDMI acceptor.
Connect the power cable on the underside to a
power source and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts
inside the unit.
Warning:
Use only the power cord that is supplied
with the unit.
Warning:
Do not open the unit. High voltages can
cause electrical shock! Servicing by
qualified personnel only.
Warning:
Disconnect the power and unplug the unit
from the wall before installing.
for updated safety information.
