Kramer Electronics Ltd.
MV-4X
– Operating and Controlling MV-4X
22
Connecting Ethernet Port Directly to a PC
You can connect the Ethernet port of
MV-4X
directly to the Ethernet port on your PC using a
crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying
MV-4X
with the factory configured default IP address.
After connecting
MV-4X
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.
The Local Area Connection Properties window for the selected network adapter appears
as shown in
Figure 6: Local Area Connection Properties Window
4. Highlight either
Internet Protocol Version 6 (TCP/IPv6)
or
Internet Protocol Version 4
(TCP/IPv4)
depending on the requirements of your IT system.
5. Click
Properties
.
The Internet Protocol Properties window relevant to your IT system appears as shown in