TBUS-1A - Installing the TBUS-1A
15
15
5.6
Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio,
HDMI and so on):
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the
TBUS-1A
.
Do not secure the cables too tightly or too loosely. Leave a small amount of
slack.
5.7
Adjusting the Height of the Inner frame
If needed, you can adjust the inner frame to one of five possible heights to
accommodate large or bulky cables. To adjust, perform the following:
1. Remove the eight height adjustment screws (two screws on the front and
back, two screws on each side, as shown in
Figure 2
), while supporting the
surface from underneath with your fingers.
2. Raise or lower the inner frame to the required height, insert the screws, and
tighten them in place.
